Quadcopter propeller direction tip, Blade 350qx Dji Phantom. RC Helicopters | Radio Control Scale Models, RC Helicopters For Sale | Buy Remote Control Helicopter

Online social commentary (media commentary):

"Great video on how to set up the direction of the props. Your picture conveys perfectly on which direction the prop should be.
Thanks, saved me some frustration."
As a newbie on this chapter...thank you very much!
"Nice video on prop installation!
Thanks!"
Such a help. Thank You! :)
Excellent video, really helped.
I love how you made me say duh. Why didn't i think of that.  I really appreciate the help.  The other videos make it so complicated and take forever.  Thanks
Hey quick question off subject but I know you have a 350qx and Fat shark FPV and I've heard the fat shark v3 can go a range of around half mile but I'm not sure how much range the stock 350qx has...I trying to figure out how far the combo of fat shark and stock 350qx will go any ideas? If you know line of sight and non line of sight range that will really help...thanks in advance
Nice tip, i always mark my propellers before balancing them and putting them on my quadcopter! After that i know if i remove them, it will be easy to put them next time! happy saturday
Wish I had seen this clip \ tutorial earlier :)  May have saved me a pair of 350QX skids.
great vid..short and sweet! thumbs up&subscribed! thx again bro
Hey, 7demo7, thanks for this.  I have a Hoten-X, with orange back props and black front props.  Until I watched this video I thought the props could just go in any way, as long as the warning statement was on the bottom.  Not so.  I took out my inventory of props, and half were for CW rotation, the others for CCW rotation, and that was just the black ones.  This video pointed out the leading edge and was quite clear about which way the props should turn.  Took my quad out and actually flew it instead of it flipping over in the grass and destroying props!  You did a good service here.  God I love YouTube!
Great tip!
Thank.my drone was damaged somehow. I had to pull out my power switch which was totally destroyed. Then I connect two ends of wires which are at a direction of power switch. After connection with battery directly all propellers moves wrong direction. My question is whether I wrongly connect the wires or I change the prop wrongly.plz answer.
Bigteedo11, the stock 350qx will go to aprox 1700-2000ft so not far. I tested my high gain antenna mod that replaced the stock wire antenna. That got me to half a mile.
Mike h, go on eBay , there is a seller I've gotten 2 motors from $25 each. They're were from destructed new quads
I'll tell you what did help, your lay out of the electronics. I took my blade apart an was gonna PVC pipe body it and forgot the layout yours confirms it I have it correct. Only problem with the PVC pipe build I'm finding is the mounting of the motors cause if you tighten too much it becomes stiff I Gota put a spacer between the blots to have it free travel
will remember that. thanks
Ok Jeff the PVC using the blade parts is a no go ill use my other quad parts I have for the PVC quad. As for the blade I used your Frankenstein method to repair the body it came out great but, I found out after I put it all together that one motor is fried. Took it apart and swapped motors to find indeed it was fried.. So the blade is down till I fork out 42$ to get a replacement motor, kinda bummed.
If you are changing to the frame that is open like this one do you think it is still necessary to mod the antenna?
Sweet Thanks