How to do the RC Tank Hull magnets conversion. (TOP 10 RC Tanks for Sale, Best RC Tanks for Sale, Radio Control Tanks Scale Model)

All RC Tanks on Earth (Full Series)

Online social commentary (media commentary):

A simple how-to video for RC tanks using rare-earth magnets instead of the screws to secure the hulls together.

Please subcribe to our channel and like this video!
This is modification is super worth while. Apart from easy access, it gives you the option to cut and dispose the stock battery comparment. You then get loads of space for a large battery, control board, speaker and whatever else you want to install. Highly recommended and it compliments the Drive Axle Bearing Support and Hull Brace modifications. These modifications give Tamiya 1/16 tanks a run for their money.
The best way to shorten the upper bases is by using a slow spinning drill. Ca. 8 mm.
Nice video! Just a little tip when you record video with a smartphone, set it in "plane mode" so you dont record messages notification sounds.
I want to do this mod so bad on my heng long abrams. Will this impact the hull stiffness? I dont have the money to buy a stiffening kit just yet and am worried it will make the hull flex too much. Thank you!
great! nice video as always
Hi! What diameter and thickness do you reccomend for 1/16 heng long m1a2 abrams? Thank tou!
How about a link to the magnets or a pic the brand packaging close up. Thanks for sharing.
Thats a good idea but do you build also your own speaker boxes? Dit it with my tank and dond need a amplifire for it. If you whant i can share it with you
"Magnet size is 6mm diameter and 3mm thick? Any recommendation link to purchase magnets? Does it matter which side is facing up for the hull (bottom) magnet?
" Honestly, a dremel or small angle grinder would probably be better to take down the posts
Very good tip! - can i use a special superglue i have? it is like gel, slow drying, about 5mins, greets, Levi
very good!!
Nice one Stanlley
"may be i am too late here Would like to know will such strong magnet interfere with the board. since the screw holes is right next to the board. i wanted do this to my t90 and planned to keep upgrade it in the future, don't want shorten it's life.
" ok can you do one on a henglong Sherman but I want to make hatches on the rear open and the two front ones but where they are is where the screws hold the body can you show where to put them and what magnets are used and can they be purchased on ebay thanks
pakai magnet nedynium kuat tak?
Hi Stanley. Have you heard of a sight called Hestia also called Hestia brave troops 10.com. Anyway I've seen a 1/16 scale metal tiger tank 1 for 45 bucks. What do you think about this price. I'm also looking at the new drift tank for 80 bucks.
Are heng long good rc tanks good?
Turn off the notifications on your phone on the back ground.. it's extremely annoying. >;(